Slabs built for the load
A slab for a garden shed and a slab for an RV or a car lift are not the same thing. We size thickness, reinforcement and base for what will sit on it, and set the slab level (or sloped to drain, when that’s what you need).
Common slab projects
Shed & storage slabs
Flat, square pads so doors close right and floors stay dry.
RV, boat & extra parking
Thicker sections and heavier reinforcement for heavy, concentrated loads.
Hot tub & equipment pads
Level pads for spas, HVAC units, generators and EV-charger equipment.
Garage & shop floors
Replacement garage slabs and shop floors with a smooth trowel finish.
ADU and structural slabs
Slabs that are part of a building — ADUs, garages, additions — are designed by an engineer and require a building permit. We build to your approved plans and coordinate inspections. See concrete foundations.
How we pour a slab
- Layout and excavation to the right depth, with forms set to exact elevation.
- Compacted aggregate base, plus a vapor barrier where the slab will be enclosed.
- Reinforcement placed on supports, sized for the load.
- Pour and finish — trowel finish for interiors, broom for exterior traction.
- Joints and curing to control cracking and reach full strength.
Slab FAQs
How thick should a shed slab be?
For most sheds a 4-inch reinforced slab on compacted base works well. Heavier uses — workshops, vehicles, equipment — call for more. We’ll spec it for your use.
Can you pour a slab in my backyard if there’s no truck access?
Yes. We can pump concrete over the house or through a side yard, or wheel it in for smaller pours.
Do I need a permit for a slab?
It depends on the city, the slab’s size and what’s being built on it. Slabs for habitable structures like ADUs always require permits; a small shed pad often doesn’t. We’ll confirm for your address.


